Descripción
The 2-Button programmable remote control DTM-ROLL/433 is part of the DTM line (Detumando S.L). They are intended to operate automations, open and close garage doors, lock and unlock tobacco machines. Receptors can be installed in a multitude of equipment such as blinds, dangerous machines or lighting and activated with these controls. This model is about Rolling Code type (DTM-ROLL). Each model has 3 channels or buttons, which are intended to be functional and compatible with receptors of the following brands, whether or not they have an installer code: APRIMATIC TR2, BFT, CLEMSA MUTANCODE, ERREKA, MATICDOOR MILENY, ROPER, NICE SMILO, JCM, PUJOL VARIO OCEAN, GIBIDI, DEA SYSTEM, FORSA, DMIL, MASTER ENGINEERS, NUEVA CASTILLA, ELEMAT, ZIBOR, HYDOM, EMFA, CUBELLS, ALFA TORRES, ELECTRO PARKING, EP, NEO, ARF 2, HIBRID PLUS, CYACSA.
PROGRAMMING
It must be programmed with our RF PLUS, ROLLING PLUS or FUTURE PLUS.
We can copy the Rolling Code remote controls indicated above, whether or not they have an installer code.
With the RF PLUS:
To program our DTM-ROLL 868 remote control, we will follow the next steps:
1.- Plug the five-pin female connector into the five-pin male connector with the black mark upward, leaving the female pin free.
2.- Put the original remote control in the copy area of the machine and check that it emits a sound when it is transmitting.
3.- Press and hold button A of our RF PLUS, the up to the right light will turn on and off quickly, without stopping pressing, we will start transmitting with the original remote, for a few seconds, without stopping transmitting until the light turn off.
4.- Do exactly the same steps as in case 4, but this time pressing and holding button B of our RF PLUS.
5.- Press button C, the RF PLUS light will flash quickly and will turn off after about 5 or 6 seconds and will remain on, otherwise you must repeat all the steps.
6.- To continue or repeat, it will always be necessary to press ENTER after storing the copy.
With the ROLLING PLUS:
Consult the Rolling Plus Manual for the process to follow, according to the brand you want to duplicate.
With FUTURE PLUS:
Consult machine manual.
Programmable remote control DTM-ROLL/433 with 3 buttons
NOTE: THIS REMOTE IS EXCLUSIVELY INTENDED FOR PROFESSIONALS. TECHNICAL KNOWLEDGE AND EQUIPMENT ARE REQUIRED FOR PROGRAMMING AS THE FUTURE NOVA.
