PROGRAMMABLE DTM-H6 REMOTE CONTROL WITH VARIABLE FREQUENCY
This DTM-H6 remote control with a frequency between 290 MHz and 440 MHz has been developed to operate automations, open and close garage doors, lock and unlock tobacco machines. Receptors can be installed in a multitude of equipment such as blinds, dangerous machines or lighting and activated with these controls. It has 2 or 4 channels or buttons, which are intended to be functional and compatible with receptors of the following brands: FACC, CELINSA, NICE, ROLLTORE, BFT, JCM, CLEMSA, CELINSA, V2, DEA SYSTEM, HORMANN, BELSON , CAME, CARDIN, GIBIDI, MATICDOOR, TELCOMA, VELLEMAN, PUJOL, ERREKA, FORSA, KAMAR, MX-ONDA, LIFT MASTER, GENIE and with practically 90% of fixed code remote controls on the market.
It must be programmed with our RF PLUS, RF DISPLAY TESTER, AITEC PROGRAMMER, FUTURE PLUS.
To program our DTM-H6 remote control with any of the brands mentioned, we will follow these steps:
1.- Connect the three-pin probe to the destination remote control as indicated in Fig. A.
2.- Having the remote control to be copied already placed on top of the duplicating machine, on the TEST AREA, we will press the button in which we want to store the code on the destination remote control; The light of this remote control will turn on intermittently, turning off after three flashes.
3.- Immediately we begin to transmit with the original remote control on the machine until the light of the destination remote control flashes. It is recommended to do steps 2 and 3 as quickly as possible. If the original remote control had several buttons, we will repeat the whole process for each button, disconnecting and connecting the probe between each programming.
4.- After duplicating the desired codes, it will be necessary to check on which frequency transmits the original remote control and adjust that frequency in our DTM-H6. To do this, we will place the remote on the programming machine and turn the screw with a ceramic or plastic screwdriver until the machine’s frequency meter shows the same frequency as it did with the original remote control.
PROGRAMMABLE REMOTE DTM-H6
NOTE: THIS REMOTE IS EXCLUSIVELY INTENDED FOR PROFESSIONALS. TECHNICAL KNOWLEDGE AND EQUIPMENT ARE REQUIRED FOR PROGRAMMING AS THE FUTURE NOVA.