DTM-Q 2 Buttons remote control

10,75 IVA NO incluido

This DTM-Q remote control can copy low frequency remote controls from 26 MHz to 40 MHz

wws Detumando Estamos aqu├ş para ayudarte! Cons├║ltanos!

Description

Programmable remote control DTM-Q 2 Buttons with the possibility of changing quartz.

 

PRODUCT DESCRIPTION

 

This DTM-Q remote control can copy low frequency remote controls from 26 MHz to 40 MHz. It has been developed to operate automations, open and close garage doors, lock and unlock tobacco machines. Receptors can be installed in a multitude of equipment such as blinds, dangerous machines or lighting and activated with these controls. It has 2 or 4 channels or buttons, which are intended to be functional and compatible with receptors of the following brands: FACC, CELINSA, NICE, ROLLTORE, BFT, JCM, CLEMSA, CELINSA, V2, DEA SYSTEM, HORMANN, BELSON , CAME, CARDIN, GIBIDI, MATICDOOR, TELCOMA, VELLEMAN, PUJOL, ERREKA, FORSA, KAMAR, MX-ONDA, LIFT MASTER, GENIE and with practically 90% of fixed code remote controls on the market.

 

PROGRAMMING

 

It must be programmed with our RF PLUS, RF DISPLAY TESTER, AITEC PROGRAMMER or FUTURE PLUS.

 

To program our DTM-Q remote control with any of the brands mentioned, we will follow these steps:

1.- Connect the three-pin probe to the DTM-Q remote control as indicated in Fig. A. Our FUTURE PLUS or RF PLUS is necessary

2.- Having already placed on top of the duplicating machine, on the TEST AREA, the remote control to be copied (Original or copy), we will press on the DTM-Q, the button in which we want to store the code; The light of this remote control will come on intermittently, turning off after three flashes.

3.- Immediately we begin to transmit with the original remote control on the machine until the light of the destination remote control flashes. It is recommended to do steps 2 and 3 as quickly as possible. If the original remote control had several buttons, we will repeat the hole process for each button, disconnecting and connecting the probe between each programming.

 

Note: It is advisable to check if the original remote control has the crystal quartz appropriated to the frequency you want to duplicate (See Fig. B); To do this, you must open the remote control (by pressure or using a screwdriver as an aid, separating both ends of the case that covers the remote control) and check the numbers that the crystal quartz has on its upper part. The crystal quartz in the original remote control must be of the same frequency as the one in the DTM-Q. We have single crystals to be able to place the correct one after making the duplicate. After this operation we must adjust the maximum transmission power of the control and follow the instructions indicated in the Manual of the Rf Plus or of the device that we are using.

Programmable DTM-Q 2 Buttons remote control

NOTE: THIS REMOTE IS EXCLUSIVELY INTENDED FOR PROFESSIONALS. TECHNICAL KNOWLEDGE AND EQUIPMENT ARE REQUIRED FOR PROGRAMMING AS THE FUTURE NOVA.

Additional information

Weight0,015 kg
Dimensions5,2 × 3,8 × 1,4 cm
Detumando
X
WeCreativez WhatsApp Support
Estamos aqu├ş para solucionar cualquiera de las dudas que tengas, preg├║ntanos!
Hola, puedo ayudarte en algo?