PROGRAMMABLE DTM-MV REMOTE CONTROL
This 433.92 MHz frequency DTM-MV remote control has been developed to operate automations, open and close garage doors, lock and unlock tobacco machines. Receptors can be installed in a multitude of equipment such as blinds, dangerous machines or lighting and activated with these controls. It has 2 or 4 channels or buttons, which are intended to be functional as compatible with receptors of the brands: CLEMSA MASTERCODE with or without installer code.
It must be programmed with our RF PLUS, AITEC PROGRAMMER, RF DISPLAY TESTER or FUTURE PLUS.
To program our DTM-MV remote control, we will follow the next steps:
1.- Connect the pin probe to the remote control.
2.- At that moment the light of the destination remote control will turn on, turning off after a few seconds.
3.- When the DTM-MV led turns off, we will start emitting with the Mastercode or the compatible remote control.
4.- When the DTM-MV is blinking, it means that the duplication has been done.
Note: Remember that you have to place the microswitches of the code for a correct work.
NOTE: THIS REMOTE IS EXCLUSIVELY INTENDED FOR PROFESSIONALS. TECHNICAL KNOWLEDGE AND EQUIPMENT ARE REQUIRED FOR PROGRAMMING AS THE FUTURE NOVA.