DTM-LOGO 2 Buttons Remote Control

10,75 IVA NO incluido

The DTM-LOGO will allow you to generate remote controls compatibles with the original GO2 ® remote controls

wws Detumando Estamos aqu├ş para ayudarte! Cons├║ltanos!

Description

The programmable DTM-LOGO remote control will allow you to generate remote controls compatibles with the original GO2 ® remote controls, which correspond to a remote control brand under Rolling Code technology. The Rolling Plus, Future Plus updated to the latest version, will be able to identify and program these remote controls. Its frequency corresponds to 868 MHz and it uses a 12V battery.

This DTM-LOGO remote control with 868 MHz frequency has been developed to operate automations, open and close garage doors. It has 2 or 4 channels, which are intended to be functional and compatible with receptors of the following brands:

 

If you have the Future Plus, you won’t need the Reader. To use the Rolling Plus, this device will be necessary.

PROGRAMMING

WITH THE ROLLING PLUS:

Consult the Rolling Plus Manual for the procedure to follow, according to the brand you want to duplicate.

Then you must follow the instructions below to autocopy it with the remote control that works on the receptor:

From a transmitter or remote control registered in an installation (transmitter A), a new transmitter can be enabled (transmitter B), without having to go to the installation (See fig 1-2). To do this, place both emitters on a non-metallic surface, so that they are in contact with the LED (indicator light) and proceed as follows:

1.- Press button 1 of Transmitter A and keep it pressed until the end of the operation.

2.- Press at the same time buttons 1 and 2 of B transmitter. This will flash the LED three times indicating that the programming has been done correctly.

3.- The light indicators of the two transmitters will turn off indicating the end of the operation.

4.- Once in the installation, press the transmitter B twice so that the receptor recognizes it. At the first press it will emit a sound signal, and at the second press it will open the door.

 

REPLACING THE BATTERY

When the battery is dead, the range and brightness of the LED is considerably reduced. Regular operation is restored by replacing the dead battery respecting its polarity. Warning: dead batteries contain polluting substances and must not be throw off with common waste, they must be remove by using the picking up methods provided for by current local regulations.

Programmable DTM-LOGO remote control

NOTE: THIS REMOTE IS EXCLUSIVELY INTENDED FOR PROFESSIONALS. TECHNICAL KNOWLEDGE AND EQUIPMENT ARE REQUIRED FOR PROGRAMMING AS THE FUTURE NOVA.

Additional information

Weight0,015 kg
Dimensions5,2 × 3,8 × 1,4 cm
Detumando
X
WeCreativez WhatsApp Support
Estamos aqu├ş para solucionar cualquiera de las dudas que tengas, preg├║ntanos!
Hola, puedo ayudarte en algo?