DTM-H6 2 Buttons Remote Control

10,75 IVA NO incluido

DTM-H6 frequency between 290 MHz and 440 MHz remote control

99749 in stock

wws Detumando Estamos aquí para ayudarte! Consúltanos!

Description

PROGRAMMABLE DTM-H6 REMOTE CONTROL WITH VARIABLE FREQUENCY

 

PRODUCT DESCRIPTION

 

This DTM-H6 remote control with a frequency between 290 MHz and 440 MHz has been developed to operate automations, open and close garage doors, lock and unlock tobacco machines. Receptors can be installed in a multitude of equipment such as blinds, dangerous machines or lighting and activated with these remote controls. It has 2 or 4 channels or buttons, which are intended to be functional and compatible with receptors of the following brands: FACC, CELINSA, NICE, ROLLTORE, BFT, JCM, CLEMSA, CELINSA, V2, DEA SYSTEM, HORMANN, BELSON , CAME, CARDIN, GIBIDI, MATICDOOR, TELCOMA, VELLEMAN, PUJOL, ERREKA, FORSA, KAMAR, MX-ONDA, LIFT MASTER, GENIE and with practically 90% of fixed code remote controls on the market.

 

PROGRAMMING

 

It must be programmed with our RF PLUS, RF DISPLAY TESTER, AITEC PROGRAMMER, FUTURE PLUS.

To program our DTM-H6 remote control with any of the brands mentioned, we will follow these steps:

1.- Connect the three-pin probe to the destination remote control as indicated in Fig. A.

2.- Having the remote control copied already placed on top of the duplicating machine, on the TEST AREA, we will press the button in which we want to store the code on the destination remote; The light of this remote control will come on intermittently, turning off after three flashes.

3.- Immediately we begin to transmit with the original remote control on the machine until the light of the destination remote control flashes. It is recommended to do steps 2 and 3 as quickly as possible. If the original remote had several buttons, we will repeat the hole process for each button, disconnecting and connecting the probe between each programming.

4.- After duplicate the desired codes, it will be necessary to check on which frequency the original remote control transmits and adjust that frequency in our DTM-H6. To do this, we will place the remote control on the programming machine and turn the screw with a ceramic or plastic screwdriver until the machine’s frequency meter shows the same frequency as it did with the original remote control.

PROGRAMMABLE DTM-H6 REMOTE CONTROL

NOTE: THIS REMOTE IS EXCLUSIVELY INTENDED FOR PROFESSIONALS. TECHNICAL KNOWLEDGE AND EQUIPMENT ARE REQUIRED FOR PROGRAMMING AS THE FUTURE NOVA.

Additional information

Weight0.015 kg
Dimensions5.2 × 3.8 × 1.4 cm
Detumando
X