Descripción
2-Button DTM-FLO Compatible Remote Control
Rolling code remote control, compatible with the NICE FLO 2R model. It is delivered programmed and it is only necessary to activate it on the receptor.
PRODUCT DESCRIPTION
This 433.92 MHz frequency DTM-FLO remote control has been developed to operate automations, open and close garage doors. It has 2 and 4 buttons, which are intended to replace the Nice FLO2R model. It is already programmed and it is only necessary to register it in the receptor.
PROGRAMMING
PROGRAMMING
Our DTM-FLO does not need special programming or any machine, it is already programmed.
You must register it in the receptor by choosing one of two options:
1.-IF YOU HAVE A NICE-Flo2r REMOTE CONTROL that is already registered in the receptor, we will proceed as follows:
a) Stand at a distance of 2 to 5 meters from the receptor.
b) Press any button on the DTM-FLO remote control.
c) Press slowly three (03) times any remote control button that has already been registered.
d) We will press the DTM-FLO control button 1 (once) again.
e) Wait for the Led (light) to turn off.
2.-IF YOU DO NOT HAVE A REMOTE CONTROL WHICH IS ALREADY REGISTERED, we will proceed from the
following form:
a) Press the button located at the top inside the receptor.
b) The Led (light) will come on for approximately five seconds, before it goes off you must press any button on the DTM-FLO remote control and when the Led goes off, release the button on the remote control.
c) Wait a few seconds and press the same button on the DTM-FLO remote control again.
d) If the programming was done correctly, the Led should flash three (03) times.
2-Button DTM-FLO Compatible Remote Control
NOTE: THIS REMOTE IS EXCLUSIVELY INTENDED FOR PROFESSIONALS. TECHNICAL KNOWLEDGE AND EQUIPMENT ARE REQUIRED FOR PROGRAMMING AS THE FUTURE NOVA.